Here's a Reset Procedure ... The problem was if error occured the unit would halt further activity so printing was suspended ... the particular error was the photo ink tank was empty and it took awhile to select everything so I could print with Black only ... photo ink error needed clearing ...
Canon BJC-8000 Overall Reset Procedure (No paper in tray) to clear errors etc
1. Disconnect powercord, Hold Down Power and Resume Buttons
2. Connect the powercord and unit will turn on
3. Release Power Button, then click it once
4. Release both Power and Resume Buttons
5. Green Power light will be on steady, amber Resume light went off
6. Then at about 1 second intervals ... click Resume, click Resume, then click Power...In a few seconds Startup Cycle Machinations will occur and finish
7. Do a Button Power off ... a Button Power on wont work ...
unplug then replug power ... Button Power on / off , Machinations OK,
error cleared now !
Here's a waste error reset from aU.K.
1. Power off printer
2. Hold Resume button then press and hold POWER, the beeper will sound once.
3. Hold POWER and release RESUME
4. Press RESUME twice
5. When the indicator lights steady, press RESUME three(3) times. The indicator should be orange.
6. Press Power to set data.
I hope this info can help you...
Canon BJC-8000 Overall Reset Procedure (No paper in tray) to clear errors etc
1. Disconnect powercord, Hold Down Power and Resume Buttons
2. Connect the powercord and unit will turn on
3. Release Power Button, then click it once
4. Release both Power and Resume Buttons
5. Green Power light will be on steady, amber Resume light went off
6. Then at about 1 second intervals ... click Resume, click Resume, then click Power...In a few seconds Startup Cycle Machinations will occur and finish
7. Do a Button Power off ... a Button Power on wont work ...
unplug then replug power ... Button Power on / off , Machinations OK,
error cleared now !
Here's a waste error reset from a
1. Power off printer
2. Hold Resume button then press and hold POWER, the beeper will sound once.
3. Hold POWER and release RESUME
4. Press RESUME twice
5. When the indicator lights steady, press RESUME three(3) times. The indicator should be orange.
6. Press Power to set data.
I hope this info can help you...
Labels: Canon
Subscribe to:
Post Comments (Atom)
0 comment:
Post a Comment